Asset Condition Management

 View Only

 how to perform multiple measurements (route) with a single enter in csi 2140

  • ACM - Asset Condition Management
  • Vibration
Raul Valencia's profile image
Raul Valencia posted 11-25-2024 10:11

Hello
Thank you for your help
I want to anchor a peakvue point with another of velocity in the ams, for when the route is made in the csi 2140, with a single enter measure velocity and peakvue.

Do you know how to do it?

Dave Reynolds's profile image
Dave Reynolds

In point setup, sensor/signal info, group number, channel number

Example

Non drive end motor, with trend spectrum waveform, velocity, accel waveform, peakvue reading, high resolution low frequency reading, all three points would have group 1, channel 1 for point setup on each point

Drive end motor with same above points would have group 2 channel 1 on all three points

Across the coupling/belt drive group 3 channel 1 on all three points and then so on repeating

You will notice when you make changes in dbase for group/channels, you should notice the changes taking place as if you made changes if that makes sense.

One push of the button then should collect all three readings

Dave

Alain RAAD's profile image
Alain RAAD

go to tools, database setup, Tree structure, select the equipment and press edit, then 'Mod Grp/Ch #' give all directions of the same point the same group number and in the channel put the channel for each direction, if you are using a triaxial sensor like the A0643TX-EX, use channel 1 for H,  2 for A and 3 for V like here for example.

N.B. if you want to remove a point you can put 0 as group and channel.

putting 2 points with different directions in the same channel will give a fault