#ACM #Vibration #Ut #Ndt #Ir
2 attachments
go to tools, database setup, Tree structure, select the equipment and press edit, then 'Mod Grp/Ch #' give all directions of the same point the same group number and in the channel put the channel for each direction, if you are using a triaxial sensor like the A0643TX-EX, use channel 1 for H, 2...
End Play Limits: Instructions for measuring distances related to shaft positioning. Measurements: Between the first shaft shoulder and the nearest stationary part: ( .3 ) inches and ( .8 ) inches. Magnetic center coupling: ( .8 ) inches. Limit end float and alignment should be done as per the...
I am hoping someone can help me understand the information on this motor data plate. It's a Siemens motor, and I particularly want to know how the limits listed pertain to the axial positioning of this motor for alignment with the compressor it operates. We tried running the motor uncoupled to...
In point setup, sensor/signal info, group number, channel number Example Non drive end motor, with trend spectrum waveform, velocity, accel waveform, peakvue reading, high resolution low frequency reading, all three points would have group 1, channel 1 for point setup on each point Drive end...
Hello Thank you for your help I want to anchor a peakvue point with another of velocity in the ams, for when the route is made in the csi 2140, with a single enter measure velocity and peakvue. Do you know how to do it?
The Association of Asset Management Professionals, Inc.
PO Box 425
Blair, NE 68008
Phone239-533-9806
Become an AMP member(It's free!)
Quick Start Guide
Certifications
About AMP
About WIRAM
Terms of Use and Privacy Policy
Terms and Conditions
Meet the Team
AMV Podcast
Newsletter
Brand Guidelines