vibration/alignment/balance

i was ever design with my team DVA for the vertical motor with 282 kW.. the resonance in 1x TS.. Motor speed : 1491 RPM.. Vibration ...

Can you paste waveforms and spectra before and after greasing? Regards- Ali Shurafa

I have 60 hp motor running a shower pump on a paper machine. Recently greased the motor bearings and as expected the g's dropped ...

Contact Taqi from ZATA Solution. you can give my reference   ------------------------------ Basit Khan -------------------- ...

Dear Members Is it possible to design DVA to counter 420CPM frequency for vertical motor.I tried by attached spreadsheet.M2 ...

Dear Yoki Can you please share your contacts,need your support. Regards ------------------------------ Rana Ali ------- ...

Bearing clearance verified multiple times, In spec.  ------------------------------ Vinny Prinu Vincent ------------------- ...

1/2 x harmonics at sleeve bearings are usually related to excessive looseness inside the bearing. I would check the tolerances. ...

we are running the motor with No-load/ solo run. Today we are going to test it with shell 46 oil. Both the bearings are overhung.  ...

PLEASE FIND ABOVE VIBRATION SPECTRUM DETAILS. Untill 21 st of june we could ppick only 1X on the spectrum but from 23rd of june ...